Figure 179. Installing the 7mm SSD riser cage
Step 4.
Connect the cables to the backplanes. See
1. Reinstall all the drives and fillers (if any) into the drive bays. See
2. Complete the parts replacement. See
Demo video
Watch the procedure on YouTube
Rear drive backplane and drive cage replacement
Follow instructions in this section to remove and install rear drive backplanes and drive cages.
•
"Remove the 4 x 2.5" drive backplane and drive cage" on page 213
•
"Install the 4 x 2.5" drive backplane and drive cage" on page 215
•
•
•
•
•
•
Remove the 4 x 2.5" drive backplane and drive cage
Follow instructions in this section to remove the rear 2.5-inch 4-bay drive backplane and drive cage.
About this task
Attention:
Chapter 6 "Internal cable routing" on page
"Complete the parts replacement" on page
Chapter 5
279.
.
Hardware replacement procedures
281.
134.
213