Install A Hot-Swap Drive" On Page - Lenovo ThinkSystem SR665 V3 User Manual

Figure 182. Installing the 4 x 2.5-inch rear drive backplane
a. Align the bottom of the backplane with the studs at the bottom of the drive cage.
b. Lower the backplane into the drive cage so that the holes in the backplane pass through the
pins on the drive cage, and press the backplane into position. The release latches will secure
the backplane in place.
Step 3. Install the rear drive cage.
Figure 183. Installing the 4 x 2.5-inch rear drive cage
a. Align the rear drive cage with the chassis, and lower the drive cage into the chassis.
b. Move the rear drive cage forward until it clicks into position.
Step 4. Connect cables to the drive backplane. See
After you finish
1. Reinstall the drives or drive fillers into the rear drive cage. See
2. Complete the parts replacement. See
ThinkSystem SR665 V3 User Guide
216
Chapter 6 "Internal cable routing" on page
"Complete the parts replacement" on page

"Install a hot-swap drive" on page

279.
281.
134.