Install A Raid Flash Power Module On The Middle 2.5-Inch Drive Cage - Lenovo ThinkSystem SR665 V3 User Manual

a. Pull out the blue latch on the supercap cover.
b. Slide the cover out of the holder.
c. Take the RAID flash power module out of the holder.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.

Install a RAID flash power module on the middle 2.5-inch drive cage

Follow instructions in this section to install a RAID flash power module (also called supercap) on the middle
2.5-inch drive cage.
About this task
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the RAID flash power module on the middle drive cage.
Figure 160. Installing the RAID flash power module on the middle drive cage
a. Put the RAID flash power module into the holder, and press it down to secure it into the
holder.
b. Align the pins on the metal cover with the holes in the supercap holder, pull out the blue
latch on the cover, and slide the cover into the holder until the pins pass through the holes.
Then, release the blue latch to lock the cover into place.
ThinkSystem SR665 V3 User Guide
198
and "Safety inspection checklist" on page 48
62.
to ensure that you