Table of Contents
Advertisement
Figure 21. Installation of a hot-swap power supply
Step 3.
Connect one end of the power cord to the AC connector on the back of the new power supply;
then, connect the other end of the power cord to a properly grounded electrical outlet.
After this task is completed
Make sure that the power LED on the power supply is lit, indicating that the power supply is operating
correctly.
PSU cage and chassis midplane replacement
Follow instructions in this section to remove or install the PSU cage and the chassis midplane.
Remove the PSU cage
Follow instructions in this section to remove the PSU cage.
About this task
To avoid potential danger, make sure to read and follow the safety information.
S001
32
ThinkSystem D3 Chassis User Guide
Advertisement
Table of Contents
