Table of Contents
Advertisement
Figure 15. Installation of the shipping brackets
Replace components in the chassis
Follow instructions in this section to remove or install components from or to the chassis.
EIA bracket replacement
Follow instructions in this section to remove or install the EIA brackets from or to the D3 Chassis.
Remove the EIA brackets from the chassis
Follow instructions in this section to remove the EIA brackets from the chassis.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read
"Installation Guidelines" on page 15
you work safely.
Procedure
Step 1.
Make preparations for this task.
a.
Power off all the nodes (see
cables from the nodes.
Note: If necessary, press the release clip with a flat-head screwdriver to remove an external
network cable from the rear of a 2U node.
24
ThinkSystem D3 Chassis User Guide
and
"Safety inspection checklist" on page 16
"Power off the system" on page
to make sure that
18); then, disconnect all external
Advertisement
Table of Contents
