Table of Contents
Advertisement
Install the EIA brackets to the chassis
Follow instructions in this section to install the EIA brackets to the chassis.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read
"Installation Guidelines" on page 15
you work safely.
Procedure
Step 1.
Align the left EIA bracket with the screw holes on the left of the chassis; then, secure it to the
chassis with the screws.
Step 2.
Repeat the same step to secure the right EIA bracket to the right of the chassis.
Figure 17. Installation of the EIA brackets
After this task is completed
• Install the chassis to the rack (see
• Reinstall each PSU slot with a PSU or PSU filler (see
Installation of a PSU
• Reinstall the nodes into the chassis.For the procedures of installing a specific node, see the links below:
– SD530 V3:
https://pubs.lenovo.com/sd530-v3/install_a_node_to_chassis
– SD550 V3:
https://pubs.lenovo.com/sd550-v3/install_a_node_to_chassis
Hot-swap power supply replacement
Follow instructions in this section to remove or install a hot-swap power supply unit (PSU).
Remove a hot-swap power supply
Follow instructions in this section to remove a power supply unit (PSU).
26
ThinkSystem D3 Chassis User Guide
and
"Install the chassis to the rack" on page
filler).
"Safety inspection checklist" on page 16
"Install a hot-swap power supply" on page 29
to make sure that
22).
and
Advertisement
Table of Contents
