Error Codes When Using Ethernet/Ip Communications - Mitsubishi Electric MELSEC iQ-R Series User Manual

Error codes when using EtherNet/IP communications

Error Error definition and causes
code
19E0H An error was detected in the data received
during EtherNet/IP communications.
31E0H The parameters of this module are not set
in the CPU.
31E1H An error was detected in the parameters
set in "EtherNet/IP Configuration".
31E2H An error was detected in the parameters
set in "EtherNet/IP Configuration".
3E05H An error was detected in the memory.
3E06H A memory error was detected during
EtherNet/IP communications.
Action
• Check whether the operating status of the external device is normal.
• Check for errors in the line status.
• The line may be busy, so retry the operation after a while.
• If the same error code is displayed again, the possible cause is a
hardware failure of the error module. Please consult your local Mitsubishi
representative.
• Set the parameters to the CPU module.
• Write the module extension parameters to the CPU module regardless of
whether EtherNet/IP communication is used.
• Check the mounting position of the module.
• Use "EtherNet/IP Configuration" to write the parameters to the module
again.
• If the same error code is displayed again, the possible cause is a
hardware failure of the error module. Please consult your local Mitsubishi
representative.
• Use "EtherNet/IP Configuration" to write the parameters to the module
again.
• If the same error code is displayed again, the possible cause is a
hardware failure of the error module. Please consult your local Mitsubishi
representative.
• Take measures to reduce noise.
• Reset the CPU module, and run it again. If the same error code is
displayed again, the possible cause is a hardware failure of the error
module. Please consult your local Mitsubishi representative.
• Take measures to reduce noise.
• Reset the CPU module, and run it again. If the same error code is
displayed again, the possible cause is a hardware failure of the error
module. Please consult your local Mitsubishi representative.
19 LIST OF ERROR CODES
19.1 Error Codes When a Module Error Occurs
Detailed
information 1
Detailed
information 2

19
■System
configuration
information 2
• I/O number
Information category:
0x07
■




433