Alternator Service - Toro Workman 3000 Series Service Manual

Alternator Service

1. Alternator pulley
2. Space collar
3. "B" terminal
4. Rear end cover
5. Brush holder assembly
Disassemble and assemble parts as shown in illustra­
tion above. Also use the following instructions for specif­
ic points of disassembly, inspection and reassembly.
Alternator Disassembly
1. Extend the four (4) terminals of stator coil as shown.
Liquid Cooled Gas Engine
14
13
1
2
9
11
12
15
5
3
7
8
Figure 100
6. Seal ring
7. IC regulator
8. Rectifier
9. Rear end frame
10. Bearing cover
Page 3 – 60
10
4
6
11. Rear bearing
12. Rotor assembly
13. Drive end frame and stator assembly
14. Front bearing
15. Retainer plate
Figure 101
Workman 3000/4000 Series