Stub Axle And Drive Shaft Service - Toro Workman 3000 Series Service Manual

Stub Axle and Drive Shaft Service

300 – 340 Nm
(220 – 250 ft–lb)
47 – 57 Nm
(35 – 42 ft–lb)
4
9
Drive Shaft with Half Yoke
1. Wheel nut
2. Wheel and tire
3. Brake drum
4. Flange nut
NOTE: Later production machines have a half yoke on
the stub axle. See inset in Figure 19.
Stub Axle and Driveshaft Removal
1. Loosen wheel nuts (Item 1).
2. Jack up rear of machine and support with jack stands.
3. Remove wheel (Item 2).
4. Remove brake drum (Item 3).
5. On early production machines, not equipped with a
half–yoke, insert modified 1–1/8� box end wrench on
stub axle flange nut (Item 4). NOTE: On machines
equipped with a half yoke type driveshaft, remove the
straps securing the bearing cross to the half yoke, then
disconnect the drive shaft. You can then use a standard
1–1/8� box end wrench.
Workman 3000/4000 Series
5
Loctite 271
10
11
8
7
Half yoke
Figure 19
5. Washer
6. Stub axle
7. Bearing with thin spacer
8. Spacer
Page 6 – 13
6
3
9. Locknut
10. Seal
11. Bearing
Figure 20
Rev. A
2
1
60 – 75 Nm
(45 – 55 ft–lb)
Drive Train