Toro Workman 3000 Series Service Manual page 190

Hide thumbs Also See for Workman 3000 Series:

Table of Contents

Assembly and Adjustment of Starter

1. Reverse steps 1 - 10 under Disassembly and Inspec

tion and also following the following instructions:

2. Set the pinion shaft end play (thrust gap) to 0.5 mm

(0.02 in.) or less by inserting an adjusting washer be

tween the center bracket and reduction gear.

A. Fit the pinion shaft, reduction gear washer and

snap ring to the center bracket.

B. Measure end play by moving the pinion shaft in

and out. If end play exceeds 0.5 mm (0.02 in.),

increase the number of adjusting washers.

3. Put grease on the following parts whenever the starter

has been overhauled:

Armature shaft gear and reduction gear

All bearings

Bearing shaft washers and snap rings

Bearing sleeves

Sliding part of lever

IMPORTANT: Never put grease on terminals,

brushes, commutator or surface that mounts to the

Liquid Cooled Diesel Engine

0.5 mm max mum

Workman 3300-D/4300-D

Chapters

Table of Contents