Installing The Engine - Toro Workman 3000 Series Service Manual

12. Remove clamps and wire ties where wiring harness,
hydraulic hoses or cables are attached to the engine.
13. Put blocking under transaxle for support.
14. Attach a hoist or block and tackle to engine for
support.
15. Remove two (2) capscrews and locknuts securing
front engine mounts to frame.

Installing the Engine

1. To install the engine, perform steps of Removing the
Engine in reverse order.
2. Install a new engine oil filter. Fill engine with the
correct oil. Fill the cooling system with a 50/50 solution
of ethylene glycol antifreeze and clean, soft water.
Check for oil and coolant leaks and repair as necessary.
3. Adjust accelerator pedal cable (See Accelerator
Pedal Adjustment).
Liquid Cooled Diesel Engine
16. Remove capscrews securing clutch bell housing to
engine.
17. Use a hoist or block and tackle to remove engine
from chassis. One person should operate hoist or block
and tackle and the other person should help guide
engine out of chassis. Move engine forward before
lifting to disengage transaxle input shaft from clutch.
18. Remove brackets and accessories from engine as
necessary.
Page 4 - 58 Workman 3300-D/4300-D