Cylinder Block
12
35 – 45 Nm
(25 – 33 ft–lb)
10
2
6
1. Taper plug
2. Dowel pin
3. Plug
4. Taper plug
5. Water drain plug
Disassemble and assemble parts as shown in illustra
tion above. Also use the following instructions for specif
ic points of disassembly, inspection and reassembly.
1. Before cleaning, check cylinder block for evidence of
coolant leaks, oil leaks or damage. Clean all parts to re
move dirt, oil, carbon deposits and water scale. Make
sure no coolant or oil holes are blocked.
2. Use a straight edge and feeler gauge to measure flat
ness of cylinder head mating surface. If measurement
exceeds the limit correct by grinding or replace.
Workman 3000/4000 Series
8
Figure 240
6. Stud
7. Dowel pin
8. Knock bushing
9. Knock bushing
10. Taper plug
Page 3 – 109
9
3
11
7
8 – 12 Nm
(6 – 9 ft–lb)
1
35 – 45 Nm
(25 – 33 ft–lb)
5
4
15 – 22 Nm
11 – 16 ft–lb)
11. Sealing cap
12. Sealing cap
13. Cylinder block
Liquid Cooled Gas Engine
12