Accelerator Pedal Adjustment
If engine throttle lever does not contact high idle stop
when accelerator pedal is fully depressed, an adjust
ment to the accelerator cable is required.
1. Put vehicle into position on a level surface, stop
engine and engage parking brake.
NOTE: Engine must NOT be running and return spring
must be attached.
2. Adjust ball joint on accelerator cable to allow 0.100 -
0.250 inch clearance between accelerator pedal and top
of diamond tread floor plate, when a 25 lb. force is
applied to center of pedal. Tighten locknut.
NOTE: If you cannot get proper accelerator pedal ad
justment, put ball joint in another hole in engine throttle
lever.
IMPORTANT: Maximum high idle speed is 3650
RPM. Do not move high idle stop bolt to get proper
accelerator pedal adjustment.
Troubleshooting
Giving Immediate attention to any indication of a prob
lem can prevent major failures, and increase the life of
the engine.
Workman 3300-D/4300-D
1
Never make more that one adjustment at a time, then
locate the trouble by a process of elimination. Remem
ber the cause is usually SIMPLE, rather than mysterious
and complicated.
Page 4 - 15
2
3
Figure 13
1. Accelerator cable
2. Ball joint
3. Locknut
Liquid Cooled Diesel Engine