Toro Workman 3000 Series Service Manual page 101

5. Check the rectifier for continuity. If there is continuity
in only one direction of the diode, it is good.
6. Measure the brush length from end of brush holder.
If it is more than the limit value, replace the brush holder.
Standard value
Brush length 10.5 mm (.413 in.)
Reassembly of Alternator
Assembly alternator in reverse order of disassembly. To
install rectifier, insert the four (4) stator coil terminals into
holes of rectifier as shown, then bend terminals to fit into
O.D. of bolts.
Workman 3000/4000 Series
Limit
4.5 mm (.177 in.)
Page 3 – 63
Figure 109
B
B
P1 P2 P3
E
E
P1
P2
Figure 110
Figure 111
Figure 112
Liquid Cooled Gas Engine
P3