Toro Workman 3000 Series Service Manual page 28

WORKMAN� 3200, 3210, 3220, and 4200 Maintenance Schedule
Minimum Recommended Maintenance Intervals
Maintenance Procedure
Check Battery Fluid Level
Check Battery Cable Connections
Check Dust Cup and Baffle
Lubricate All Grease Fittings
Inspect Condition and Wear of Tires
Check Front Differential Oil Level (4WD)
� Change Engine Oil and Filter
Inspect Cooling System Hoses
Check Governor Oil Level
� Check Cable Adjustments
Check Alternator, Governor and Fan Belts
Change Air Cleaner Filter
Check Front Axle CV Boot Joint (4WD)
Check Engine RPM (Idle and Full Throttle)
�
Torque Wheel Lug Nuts
Check Front Wheel Alignment
Inspect Service and Parking Brakes
Inspect Fuel Lines
Replace Fuel Filter
Adjust Valves
Replace Spark Plugs and Check Timing
�
Replace Transaxle Filter
Change Transaxle Oil
Clean Transaxle Strainer
Pack Front Wheel Bearings (2WD)
Change Front Differential Oil (4WD)
� Initial break in at 10 hours
� Initial break in at 50 hours
Replace all Interlock Switches
Flush/Replace Coolant System Fluid
Change Brake Fluid
Replace Engine Timing Belt
(See Operator's and Service Manual for specifications an procedures)
Product Records and Maintenance
Maintenance Interval & Service
Every
Every
100hrs
50hrs
A Level
Service
B Level
Service
Annual Recommendations:
Replace switches, Coolant and Brake Fluid every
1200 hours or 2 years, whichever occurs first.
Replace Engine Timing Belt every 2000 hours or 2
years, whichever occurs first.
Page 2 – 16
Rev. D
Every
Every
Every
800hrs
400hrs
200hrs
C Level
Service
D Level
Service
E Level
Service
Workman 3000/4000 Series