Toro Workman 3000 Series Service Manual page 277

6. Assemble Hi–Lo fork shaft:
A. Install E–ring (Item 4) onto fork shaft (Item 5).
B. Insert spring (Item 3) and steel ball (Item 2) into
fork (Item 1).
C. Insert fork shaft into fork. Put moly disulfide
grease onto the shaft before installing.
7. Assemble R–1 and 2–3 fork shaft:
A. Insert R–1 fork shaft (Item 2) into R–1 fork (Item
3).
B. Drive lock pin (Item 1) into fork and fork shaft. Pay
attention to direction of slit in lock pin.
C. Insert 2–3 fork shaft (Item 2) into 2–3 fork (Item
3).
D. Drive lock pin (Item 1) into fork and fork shaft.
Pay attention to direction of slit in lock pin.
Workman 3000/4000 Series
1
Page 6 – 39
5
4
3
2
Figure 87
Figure 88
Drive Train