Shift Cable Adjustment
1st–Rev. / 2nd–3rd Cable Adjustments
1. Move shift lever to neutral.
2. Remove clevis pins securing shift cables 1st–Rev.
and 2nd–3rd cables to transaxle shift arms.
3. Loosen clevis jam nuts and adjust each clevis so
cable free play is equal forward and backward relative to
hole in transaxle shift arm (with transaxle lever free play
taken up in same direction).
4. Reinstall clevis pins and tighten jam nuts after adjust
ments have been made.
5. Make sure force limiter spring has a length of 20 mm
(.8�). Adjust length by tightening or loosening lock nut.
6. Adjust shift stops after doing shift cable adjustments:
A. Shift lever forward to 2nd gear position.
B. Hold lever in position.
C. Back out shift stop screw until screw makes con
tact with shift lever.
D. Hold stop screw and tighten jam nut.
E. Repeat steps A – D with shift lever moved forward
to Rev. gear position.
High–Low Cable Adjustment
1. Remove clevis pin securing High–Low cable to trans
axle (Fig. 12).
2. Loosen clevis jam nut and adjust clevis so clevis hole
aligns with hole in High–Low shift arm.
3. Reinstall clevis pin and tighten jam nut after doing ad
justment.
Workman 3000/4000 Series
3
1. Force limiter spring
Page 6 – 7 Rev. D
2
1
4
Figure 12
1. Shift arm (1st – Rev.)
2. Shift arm (2nd – 3rd)
3. Shift arm (High – low)
4. Transaxle shift arm hole
1
Figure 13
1
Figure 14
1. Shift stop bolt
Drive Train