Steering Wheel Installation; Steering Linkage Service - Toro Workman 3000 Series Service Manual

Steering Wheel Installation

1. Slide foam seal, steering wheel and washer onto
steering shaft.
2. Secure steering wheel to shaft with jam nut and tight-
en to a torque of 10 – 15 ft–lb (13 – 20 Nm).
3. Install cap to steering wheel.

Steering Linkage Service

Wash nylon bearings with water
DO NOT lubricate
Note: Do not attempt to disassemble U–joints. U–joint
parts are not replaceable.
Note: The pitman arm has a splined and tapered joint.
Use a puller when removing.
Steering, Brakes and Suspension
1. Foam seal
2. Steering wheel
Figure 18
1. Disassemble and reassemble as shown in illustra-
tion.
Page 7 – 18 Rev. D
4
2
1
Figure 17
3. Washer 5. Cap
4. Jam nut
Pitman Arm (4WD)
Pitman Arm (2WD)
180 – 210 ft–lb
(244 – 285 Nm)
Workman 3000 Series
5
3