Adjustments; Adjustments; Clutch Pedal - Toro Workman 3000 Series Service Manual

Adjustments

Clutch Pedal Adjustment
1. Loosen jam nuts securing clutch cable to bracket on
bell housing.
NOTE: Ball joint may be removed and rotated, if addi­
tional adjustment is required.
2. Disconnect return spring from clutch lever.
3. Adjust jam nuts/or ball joint until bottom rear edge of
clutch pedal is "A" from top of floor plate diamond pat­
tern, when an 4 lb. force is applied to pedal.
Vehicle
Workman 3200 / 3100
Workman 3300–D
NOTE: Force is applied so release bearing lightly con-
tacts pressure plate fingers.
4. Verify that rear edge of clutch pedal is 140 + 3 mm
(5.5� + .12�) from top of floor plate diamond pattern. If
dimension is not attained, adjust clutch pedal up stop.
NOTE: The clutch free play should never be less than 19
mm (.75�).
5. Tighten jam nuts after adjustment has been attained.
6. Recheck clutch safety switch adjustment. Engine
must not crank unless clutch pedal is 32 + 3 mm (1.25�
+ .12�) from floor. If an adjustment is required, loosen
switch jam nuts and adjust up or down.
Drive Train
Dimension "A"
95 + 3 mm (3.75� + .12�)
108 + 3 mm (4.25� + .12�)
Page 6 – 6
4
3
Figure 9
1. Clutch cable
2. Jam nuts
2
Figure 10

1. Clutch pedal

Figure 11
1. Clutch switch
Workman 3000/4000 Series
2
1
3. Return spring
4. Ball joint
1
2. Clutch pedal up–stop
1