Toro Workman 3000 Series Service Manual page 264

18. To remove shift arms (Transaxle Model KT40):
A. Loosen shift arm clamp bolt (Item 1) with a 3/16�
Allen wrench.
B. Loosen nut (Item 2), then remove 2nd–3rd shift
arm (Item 3) together with shift arm plate (Item 4),
spring (Item 5), locknut (Item 6), washer (Item 7)
and capscrew (Item 8).
C. Loosen locknut (Item 9) and remove washer
(Item 10). Remove 1st–Rev. shift arm (Item 11) and
High–Low shift arm (not shown).
D. Loosen capscrews(Item 12) and remove keeper
plates (Item 13).
E. Remove oil seals (Item 14).
F. Inspect shift arms and keeper plates for bending
or damage and replace if necessary.
19. To remove shift arms (Transaxle Model KT40A):
A. Loosen nut (Item 1) and washer (Item 2), then re-
move 2nd–3rd shift arm (Item 3) together with shift
arm plate (Item 4), spring (Item 5), locknut (Item 6),
washer (Item 7) and capscrew (Item 8).
B. Loosen locknut (Item 9) and remove washer
(Item 10). Remove 1st–Rev. shift arm (Item 11) and
High–Low shift arm (not shown).
C. Loosen capscrews (Fig. 50, Item 12) and remove
keeper plates (Item 13).
D. Remove oil seals (Item 14).
E. Inspect shift arms and keeper plates for bending
or damage and replace if necessary.
Drive Train
14
Page 6 – 26
2
8
4
7
6
5
3
3
9
1
10
11
4
Figure 51
12
13
Figure 52
1
2
4
8
6
7
5
3
9
10
11
Figure 53
Workmand 3000 /4000 Series