3. Check depth of undercuts between segments.
4. Check for continuity between brush and yoke as
shown. Replace the field coil if there is no continuity.
5. Make sure pinion on overrunning clutch locks when
it is turned counterclockwise and moves smoothly when
it is turned clockwise. Check pinion for wear and dam
age.
6. Check surface of brushes where they contact com
mutator. If surface is too rough, replace brush. If brush
length is less than 1/3 of standard value, replace the
brush.
Workman 3000/4000 Series
Segment
Page 3 – 67
Undercut
Mica
Figure 121
Figure 122
Figure 123
Figure 124
Liquid Cooled Gas Engine