Distributor Installation
1. Remove timing belt cover A.
2. Turn crankshaft clockwise and align mating marks on
camshaft sprocket and rear timing belt cover to bring
No. 1 cylinder to top dead center on compression stroke.
3. Align mating marks on distributor housing and cou
pling.
4. Install distributor to engine while aligning stud with
elongated hole on distributor flange.
Workman 3000/4000 Series
Tiiming belt
cover A
Rear timing
belt cover
Mating
mark
Page 3 – 71
Figure 133
Rotation
Camshaft
sprocket
Figure 134
Figure 135
Figure 136
Liquid Cooled Gas Engine