Removing and Installing the Engine
Removing the Engine
1. Put machine on a level surface and engage parking
brake. Stop the engine and remove key from ignition
switch. Remove the bed or other attachment(s). Allow
engine and radiator to cool.
2. Disconnect positive (+) and negative (–) battery
cables from battery.
3. Remove the starter assembly, leaving wires con
nected, then move starter off to the side.
4. Remove induction chamber mounting bolts. Discon
nect intake hose from carburetor. Disconnect breather
hose from induction chamber, then move induction
chamber out of the way.
5. Open radiator cap. Put a drain pan under radiator.
Open radiator drain valve and allow coolant to drain into
drain pan.
Workman 3000/4000 Series
Figure 156
DO NOT open radiator cap or drain coolant if
engine or radiator is hot. Pressurized, hot
coolant can escape and cause burns.
Ethylene–glycol antifreeze is poisonous. Dis
pose of it properly or store in a properly la
beled container away from children or pets.
6. Disconnect coolant and radiator hoses from engine.
7. Remove the muffler.
8. Disconnect fuel lines from carburetor. Plug end of fuel
lines to prevent contamination.
Page 3 – 79
CAUTION
Liquid Cooled Gas Engine