Clutch Service - Toro Workman 3000 Series Service Manual

Clutch Service

7 – 9 Nm (5 – 7 ft–lb)
13
Clutch Release Mechanism
1. Remove transaxle.
2. Inspect main shaft of transaxle for wear or damaged
splines.
3. Remove roll pin (Item 1), then remove release bearing
(Item 2). Inspect release bearing and replace if it is loose
on the sleeve, if it appears burned or is worn. Make sure
release bearing slides freely on release guide. (Item 3).
4. Inspect clutch fork (Item 4), release shaft (Item 5), and
bushings (Item 6) for wear or damage. Inspect extension
spring (Item 8). Replace worn or damaged parts. Re-
place seals (Item 9).
5. If release bearing has metal inside diameter, apply
"Never–Seez" or equivalent to the following:
– Fill annular groove of release bearing.
– Coat remainder of bearing bore.
– Apply thin coat to release guide bore.
– Apply thin coat to fingers of clutch fork.
– Remove any excess Never–Seez.
(Bearing with plastic inside diameter does not require
lubrication).
Drive Train
5
Silicone sealant
(Workman 3100 only)
10
11
12
2
Page 6 – 20
9
6
1
4
3
Never–Seez (if bearing has metal inside diameter)
Figure 31
8
6
9
Figure 32
Workman 3000/4000 Series