Differential Lock Cable; Pto Cable - Toro Workman 3000 Series Service Manual

Differential Lock Cable Adjustment
Note: On units without a Differential Lock lever, do not
perform this adjustment.
1. Move differential lock lever to OFF position.
2. Loosen jam nuts securing differential lock cable to
bracket on transaxle.
3. Adjust jam nuts to obtain 0.9 + 0.6 mm (.035� + .025�)
gap between spring hook and O.D. of hole in transaxle
lever.
4. Tighten jam nuts after adjustment has been made.
PTO Cable Adjustment
1. Remove clevis pin securing PTO cable to PTO arm.
2. Loosen clevis jam nut and adjust clevis so clevis hole
aligns with hole in PTO arm.
3. Reinstall clevis pin and tighten jam nut after doing ad­
justment.
Drive Train
3
Page 6 – 8 Rev. D
2
1
Figure 15

1. Differential lock cable

2. Transaxle bracket
3. Spring
2
Figure 16
1. PTO lever arm
2. Cable clevis
Workman 3000/4000 Series
0.9 ± 0.6 mm
(.035� ± .025�)
1