Toro Workman 3000 Series Service Manual page 282

13. Assemble shift arms (Transaxle Model KT40):
A. Install 3 new oil seals (Item 14) onto transaxle
case. Apply multi–purpose grease on lips of oil
seals before installing.
B. Install 3 keeper plates (Item 13) and tighten 3
capscrews (Item 12) to a torque of 15 – 17 Nm (11
– 13 ft–lb).
IMPORTANT: This sequence for installing the shift
arms must be followed in sequence. Fully tighten
shift arm clamp bolts before tightening retaining
nuts, or shift arm will work loose in a short period of
time.
C. Install 2 shift arms (Item 11) and washers (Item
10). Install shift arm assembly (Item 8, 7, 6, 5, 4, 3).
D. Lightly tighten shift arm retaining nuts (Item 9, 2).
E. Tighten shift arm clamp bolts (Item 4, 1) with a
3/16� Allen wrench.
F. Tighten shift arm retaining locknuts (Item 9, 2) to
a torque of 24.5 – 29.5 Nm (18.5 – 22 ft–lb). Make
sure you hold the shift lever in position while tighten-
ing the retaining nuts.
14. Assemble shift arms (Transaxle Model KT40A):
A. Install 3 new oil seals (Item 14) onto transaxle
case. Apply multi–purpose grease on lips of oil
seals before installing.
B. Install 3 keeper plates (Item 13) and tighten 3
capscrews (Item 12) to a torque of 15 – 17 Nm (11
– 13 ft–lb).
C. Apply Loctite 680 or equivalent to threads and ta-
pers of shift fork arms.
D. Install 2 shift arms (Item 11). Install shift arm as-
sembly (Item 8, 7, 6, 5, 4, 3).
E. Install washers (Item 10, 2) and locknuts (Item 9,
1). Tighten shift arm retaining locknuts to a torque
of 24.5 – 29.5 Nm (18.5 – 22 ft–lb).
Drive Train
14
Apply Loctite 680
to threads and tapers
Page 6 – 44
2
8
4
7
6
5
3
3
9
1
10
11
4
Figure 100
12
13
Figure 101
1
2
4
8
6
7
5
3
9
10
11
Figure 102
Workmand 3000 /4000 Series