Toro Workman 3000 Series Service Manual page 296

7. Disassemble PTO idle shaft:
A. Use a bearing puller to remove bearing (Item 1)
if necessary.
8. Disassemble PTO shaft:
A. Use a bearing puller to remove bearing (Item 1).
B. Remove gear (Item 2) and snap ring (Item 3).
C. Remove snap ring (Item 4) and washer Item 5).
D. Use a bearing puller to remove bearing (Item 6)
if necessary.
9. Disassemble shift arm:
A. Remove 2 lock pins from shift arm.
B. Remove 2 O–rings (Item 1).
Drive Train
6
3
Page 6 – 58
Figure 140
Figure 141
2
Figure 142
1
Figure 143
Workman 3000/4000 Series
1
5
4
5
1