Table of Contents
Advertisement
Figure 65
1. Brake-fluid reservoir
6.
If the fluid level is low, perform the following:
A.
Clean the area around the reservoir cap
and remove the cap
B.
Add DOT 3 brake fluid to the reservoir until
the fluid level is above the Minimum line
(Figure
65).
Note:
Do not overfill the reservoir with
brake fluid.
C.
Install the reservoir cap
7.
Close the hood of the machine.
Inspecting the Brakes
Service Interval: Every 100 hours
Important:
Brakes are a critical safety component
of the machine. Closely inspect them at the
recommended service interval to ensure optimum
performance and safety.
•
Inspect the brake lining for wear or damage. If the
lining (brake pad) thickness is less than 1.6 mm
(1/16 inch), replace the brake lining.
•
Inspect the backing plate and other components
for signs of excessive wear or deformation.
Replace any deformed components.
•
Check the brake-fluid level; refer to
Brake-Fluid Level (page
All manuals and user guides at all-guides.com
g002136
2. Minimum line
(Figure
64).
(Figure
64).
Checking the
51).
Replacing the Service and
Parking-Brake Pads
Service Interval: Every 400 hours
Contact your authorized Authorized Service Dealer
to inspect and possibly replace the service and
parking-brake pads.
Changing the Brake Fluid
Service Interval: Every 1,000 hours
Contact your authorized Toro distributor.
52
Advertisement
Table of Contents
