Adjusting The Neutral Gear-Shift Position; Maintaining The Primary Drive Clutch; Reducing The Top Speed - Toro Workman Operator's Manual

Gtx efi utility vehicle
Table of Contents

Advertisement

Adjusting the Neutral
Gear-Shift Position
1.
Loosen the jam nuts on the gear-shift cable and
adjust them as necessary
Figure 62
1. Shift lever
2. Spanner bar
2.
Test the gear-shift position by rotating the
gear-shift selector to the 3 different positions
and check to see if the shift lever
shifts properly when shifting the gears; refer to
Gear-Shift Lever and Gear-Shift Indicator (page
12).
3.
Verify that all of the positions are working
correctly by repeating the steps in
Neutral Gear-Shift Position (page
Maintaining the Primary
Drive Clutch
Service Interval: Every 400 hours/Yearly (whichever
comes first)
CAUTION
The dust in the clutch will become airborne
and could damage your eyes or you could
inhale it, causing breathing difficulties.
Wear safety goggles and a dust mask or
other eye and respiratory protection when
performing this procedure.
1.
Raise and latch the cargo bed.
2.
Remove the 3 bolts securing the cover to the
clutch, and remove the cover
Note:
Retain the cover and bolts for installation.
(Figure
62).
g034455
3. Gear-shift cable
4. Jam nuts
(Figure
62)
Checking the
48).
(Figure
63).
1. Cover
3.
Thoroughly clean the inside of the cover and
the inner components of the clutch using
compressed air.
4.
Install the clutch cover and secure it with the 3
bolts
(Figure
63) that you removed in 2.
5.
Lower the cargo bed.

Reducing the Top Speed

CAUTION
The dust in the clutch will become airborne
and could damage your eyes or you could
inhale it, causing breathing difficulties.
Wear safety goggles and a dust mask or
other eye and respiratory protection when
performing this procedure.
1.
Raise and latch the cargo bed; refer to
the Cargo Bed to the Service Position (page
2.
Remove the bolts securing the primary clutch
cover as shown in
Important:
Use caution when removing
the clutch cover; the spring is under
compression.
Important:
Take note of the X orientation
on the clutch covers and clutch assemblies
for later installation.
49
Figure 63
2. Bolts
Figure
64.
g011947
Raising
20).

Advertisement

Table of Contents
loading

This manual is also suitable for:

07059lt

Table of Contents