Settings; Diagnostics; Stand-Alone Mode (Ext1); Block Diagram: Start, Stop, Direction Source For Ext1 - ABB ACS800 Firmware Manual

56

Settings

Panel key
LOC/REM
Parameter
11.02
10.01
11.03
10.02
11.06
Group
MODULES

Diagnostics

Actual signals
01.11,
03.02

Stand-alone mode (EXT1)

In the stand-alone mode, a speed-controlled crane is controlled in control location
EXT1. Homing is also possible only from location EXT1. For more information, see
section
and a separate Master/Follower Application Guide [3AFE64590430 (English)].

Block diagram: start, stop, direction source for EXT1

The figure below shows the parameters that select the interface for start, stop, and
direction for external control location EXT1.
DI1 / Std IO
DI6 / Std IO
Fieldbus adapter slot 1
CH0 / RDCO board
Standard Modbus Link
Control panel
DI1 / Std IO = Digital input DI1 on the standard I/O terminal block
Program features
Additional information
Selection between local and external control
Selection between EXT1 and EXT2
Start, stop, direction source for EXT1
Reference source for EXT1
Start, stop, direction source for EXT2
Reference source for EXT2
98 OPTION Activation of the optional I/O and serial communication
Additional information
01.12 EXT1 reference, EXT2 reference
EXT1 / EXT2 selection bit in a packed boolean word
Master/Follower use of several drives (Only in EXT2 Control)
Fb. selection
See chapter
Fieldbus
DI1
DI6
COMM.
CW
control.
KEYPAD
on page 94
Select
EXT1
Start/stop/
direction
10.01