ABB ACS800 Firmware Manual page 165

Index Name/Selection
AI5
AI5/JOYST
AI6/JOYST
DI11U,12D(R)
DI11U,12D
PARAM 11.11
AI1 BIPOLAR
11.07 EXT REF2 MINIMUM
0 ... 100%
11.08 EXT REF2 MAXIMUM Defines the maximum value for external reference REF2 (absolute value).
0 ... 600%
11.09 EXT 1/2 SEL PTR
-255.255.31 ...
+255.255.31 / C.-
32768 ... C.32767
11.10 EXT 1 REF PTR
-255.255.31 ...
+255.255.31 / C.-
32768 ... C.32767
11.11 EXT 2 REF PTR
-255.255.31 ...
+255.255.31 / C.-
32768 ... C.32767
11.12 SLOW DOWN REF
0 ... 100%
11.13 JOYSTICK WARN TD Defines the time delay for Joystick check warning in case of a joystick
0 ... 10 s
Description
See parameter 11.03.
See parameter 11.03.
See parameter 11.03.
See parameter 11.03.
See parameter 11.03.
Source selected with Par.
See parameter 11.03 EXT REF1
Defines the minimum value for external reference REF2 (absolute value).
Corresponds to the minimum setting of the source signal used.
Setting range in percent. Correspondence to the source signal limits:
- Source is an analogue input: See the example in parameter 11.04.
- Source is a serial link: See chapter
Corresponds to the maximum setting of the source signal used.
Setting range. Correspondence to the source signal limits:
- Source is an analogue input: See parameter 11.04.
- Source is a serial link: See chapter
Defines the source or constant for value Par.
Parameter index or a constant value. See parameter
the difference.
Defines the source or constant for value Par.
Parameter index or a constant value. See parameter
the difference.
Defines the source or constant for value Par.
Parameter index or a constant value. See parameter
the difference.
Defines the absolute speed reference limit in Slowdown mode. Value in
percentage of the motor maximum or minimum speed defined in Par.
Par. 20.01. If in Scalar Mode then maximum or minimum frequency defined in
Par. 20.08 or Par. 20.07. See Par.
Setting range
hardware error. Joystick error is detected, if zero speed selection is true and
the speed reference or torque reference is greater than +/- 10% of minimum or
maximum scaled value of the used joystick reference. If Start commands in
both the direction is true simultaneously, then also it is detected as a joystick
hardware error.
Setting range
11.11 EXT2 REF PTR.
SELECT.
Fieldbus control.
Fieldbus control.
11.09 of parameter 11.02.
11.10 of parameter 11.03.
11.11 of parameter 11.06.
10.09 also
10.04 for information on
10.04 for information on
10.04 for information on
20.02 or
Actual signals and parameters
165
FbEq
12
13
14
15
16
17
18
0 ... 10000
0 ... 6000
-
-
-
0 ... 100
0 ... 100