How To Display The Full Name Of The Actual Signals; How To View And Reset The Fault History - ABB ACS800 Firmware Manual

How to display the full name of the actual signals

Step Action
1. To display the full name of the three actual signals.
2. To return to the Actual Signal Display Mode.

How to view and reset the fault history

Note: The fault history cannot be reset if there are active faults or warnings.
Step Action
1. To enter the Actual Signal Display Mode.
2. To enter the Fault History Display.
3. To select the previous (UP) or the next fault/warning
(DOWN).
To clear the Fault History.
4. To return to the Actual Signal Display Mode.
Press key Display
Hold
1 L -> 1242.0 rpm I
FREQUENCY
CURRENT
ACT
POWER
Release
1 L -> 1242.0 rpm I
FREQ
CURRENT
ACT
POWER
Press key Display
1 L -> 1242.0 rpm I
FREQ
ACT
CURRENT
POWER
1 L -> 1242.0 rpm I
1 LAST FAULT
+OVERCURRENT
6451 H 21 MIN 23 S
1 L -> 1242.0 rpm I
2 LAST FAULT
+OVERVOLTAGE
1121 H
1 L -> 1242.0 rpm I
RESET
2 LAST FAULT
H
1 L -> 1242.0 rpm I
FREQ
CURRENT
POWER
43
45.00 Hz
80.00 A
75.00 %
45.00 Hz
80.00 A
75.00 %
1 MIN 23 S
MIN S
45.00 Hz
80.00 A
75.00 %
Control panel