Actual Signal Display Mode; How To Select Actual Signals To The Display - ABB ACS800 Firmware Manual

42

Actual signal display mode

In the Actual Signal Display Mode, you can:
• have three actual signals on the display at a time
• select the actual signals to display
• view the fault history
• reset the fault history.
The panel enters the Actual Signal Display Mode when you press the ACT key, or if
you do not press any key within one minute.

How to select actual signals to the display

Step Action
1. To enter the Actual Signal Display Mode.
2. To select a row (a blinking cursor indicates the selected
row).
3. To enter the actual signal selection function.
4. To select an actual signal.
To change the actual signal group.
5.a To accept the selection and to return to the Actual Signal
Display Mode.
5.b To cancel the selection and keep the original selection.
The selected keypad mode is entered.
Control panel
Press key Display
1 L -> 1242.0 rpm I
FREQ
ACT
CURRENT
POWER
1 L -> 1242.0 rpm I
FREQ
CURRENT
POWER
1 L -> 1242.0 rpm I
ENTER
1 ACTUAL SIGNALS
04 CURRENT
80.00 A
1 L -> 1242.0 rpm I
1 ACTUAL SIGNALS
05 TORQUE
1 L -> 1242.0 rpm I
ENTER
FREQ
TORQUE
POWER
1 L -> 1242.0 rpm I
ACT PAR
FREQ
CURRENT
POWER
FUNC DRIVE
45.00 Hz
80.00 A
75.00 %
45.00 Hz
80.00 A
75.00 %
70.00 %
45.00 Hz
70.00 %
75.00 %
45.00 Hz
80.00 A
75.00 %