User Macros - ABB ACS800 Firmware Manual

132

User macros

In addition to the standard application macros, it is possible to create two user
macros.
User macro 1
EXT1
Stand-alone
speed control
EXT2
Master/Follower and Synchro
control
User macro 2
EXT1
Stand-alone
speed control
EXT2
Master/Follower and Synchro
control
The user macro allows you to save the parameter settings including Group 99, and
the results of the motor identification into the permanent memory, and to recall the
data at a later time. The panel reference is also saved, if the macro is saved and
loaded in the Local control mode. The Remote control location setting is saved into
the user macro, but the Local control location setting is not.
To create User Macro 1:
• Adjust the parameters. Perform the motor identification if it has not been
performed yet.
• Save the parameter settings and the results of the motor identification by
changing the parameter
ENTER). The storing takes 20 s to 1 min.
Note: If the user macro save function is executed several times, the drive memory
fills up and file compression starts. The file compression can last up to 10 minutes.
Macro saving will be completed after the file compression. (The operation is
indicated on the last row of the control panel display by blinking dots).
Application macros, control location EXT1/EXT2
16.05
99.02 APPLICATION MACRO to USER 1 SAVE (press
USER MACRO IO CHG