Setting Up Communication Through Advant Controller - ABB ACS800 Firmware Manual

Setting up communication through Advant controller

The Advant controller is connected via DDCS link to channel CH0 of the RDCO
module.
• AC 800M Advant Controller
Optical ModuleBus connection: TB811 (5 MBd) or TB810 (10 MBd) Optical
ModuleBus Port Interface required. See section
below.
For more information, see AC 800M Controller Hardware Manual [3BSE027941
(English)], AC 800M/C Communication, Protocols and Design Manual [3BSE028811
(English),] ABB Industrial Systems, Västerås, Sweden.
• AC 80 Advant Controller
Optical ModuleBus connection: TB811 (5 MBd) or TB810 (10 MBd) Optical
ModuleBus Port Interface required. See section
below.
• CI810A Fieldbus Communication Interface (FCI)
Optical ModuleBus connection
TB811 (5 MBd) or TB810 (10 MBd) Optical ModuleBus Port Interface required.
The TB811 Optical ModuleBus Port Interface is equipped with 5 MBd optical
components and the TB810 is equipped with 10 MBd components. All optical
components on a fibre optic link must be of the same type since 5 MBd components
do not match with 10 MBd components. The choice between TB810 and TB811
depends on the equipment it is connected to. With RDCO Communication Option
Module, the Interface is selected as follows:
If branching unit NDBU-85/95 is used with CI810A, TB810 Optical ModuleBus Port
Interface must be used.
Optional ModuleBus Port
Interface
TB811
TB810
Optical ModuleBus connection
Optical ModuleBus connection
DDCS Communication Option Module
RDCO-01 RDCO-02
×
RDCO-03
× ×
Fieldbus control
235