ABB ACS800 Firmware Manual page 22

22
Set the deceleration time 1.
Set the deceleration time 2.
Note: The default setting of acceleration and deceleration selection
is ACC/DEC DIR, where the acceleration time 1 and deceleration
time 1 are used if the motor is running in the forward direction, and
acceleration time 2 and deceleration time 2 are used if the motor is
running in the reverse direction.
Start-up and control through the I/O interface
The drive is now ready for use.
1 L-> 0.0 rpm
22 ACCEL/DECEL
03 DECEL TIME 1
[ ]
1 L-> 0.0 rpm
22 ACCEL/DECEL
05 DECEL TIME 2
[ ]
O
O