Table of Contents
Advertisement
IPC6125-WDL-FA
Configuration Guide
through an access port. If the switch in the network has been configured with 802.1X
parameters, the 802.1X parameters also need to be configured on the IPC. Otherwise, you
may not log in to the IPC.
802.1X parameters set on the IPC are valid only when the switch supports the MD5 authentication.
Procedure
Step 1 Choose Settings > Network Configuration > 802.1X Parameters.
The 802.1X Parameters page is displayed, as shown in
Figure 7-9 802.1X Parameters page
Step 2 Select Enable.
Step 3 Select Enable EAP-MD5.
l If the network switch uses the MD5 authentication mode, EAP-MD5 must be enabled. Otherwise, the
l Enabling EAP-MD5 switch has security risks, please exercise caution.
Step 4 Set EAPOL version, EAP identity, and password. EAPOL is short for extensible
authentication protocol over LAN.
l Obtain specific parameter values from the network administrator.
l The password is optional. To improve security, you are advised to set a password. The password length
Issue 01 (2016-08-20)
NOTE
NOTE
authentication will fail.
NOTE
ranges from 1 to 30 characters.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Setting Network Parameters
Figure
7-9.
80
Hide quick links:
Advertisement
Table of Contents
