Setting Alarm Linkage Policy Parameters - Huawei IPC6125-WDL-FA Configuration Manual

IPC6125-WDL-FA
Configuration Guide
You can modify or delete existing alarm deployment plans. To modify or delete an alarm deployment plan,
select the incident type to which the alarm deployment plan belongs and click Modify or Delete in
Deployment time.
----End

10.4 Setting Alarm Linkage Policy Parameters

When an exception such as lens block occurs, the system can trigger proper actions according
to the preset alarm linkage policy.
Procedure
Step 1 Choose Settings > Alarm Configuration > Alarm Linkage Policy.
The Alarm Linkage Policy page is displayed, as shown in
Figure 10-5 Alarm linkage policy tab page
Step 2 Set parameters. For detailed parameter description, see
Table 10-3 Parameter description
Parameter
Alarm event
Alarm output
Enable snapshot
Enable recording
Issue 01 (2016-08-20)
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Setting Alarm Parameters
Figure 10-5.
Table 10-3.
Description
Indicates the alarm event to link.
Indicates the alarm output device.
Indicates whether to enable snapshot taking.
If Enable snapshot is selected, you can set
Snapshot number and Snapshot interval.
When an alarm is generated, the system
takes snapshots based on the specified rules
and saves the snapshots to the SD card.
Indicates whether to enable recording. If
Enable recording is selected, you can set
Rec Time.
When an alarm is generated, the system
records video based on the specified
recording time and saves the recording to
the SD card.
143