Setting Bandwidth Adaptive Parameters; Setting 802.1X Parameters - Huawei IPC6125-WDL-FA Configuration Manual

IPC6125-WDL-FA
Configuration Guide
l The value of Traffic shaping coefficient ranges from 1.3 to 4.0 with a step of 0.1. A smaller coefficient
l The traffic shaping function must be supported by the cache capability on the decoding side. Set a proper
Step 5 Click Save.
----End

7.4 Setting Bandwidth Adaptive Parameters

With the bandwidth adaptive function enabled, the IPC will use an appropriate bit rate that
best suits the current network conditions to transfer video images. This approach ensures the
image quality.
Prerequisites
Bandwidth adaptive parameters are available only when:
l
l
l
l
Do not enable the bit rate stream smoothing function when the self-adaptive bandwidth function is enabled.
Otherwise, the bandwidth may be inaccurately calculated.
Procedure
Step 1 Choose Settings > Network Configuration > Bandwidth Adaptive Parameters.
The Bandwidth Adaptive Parameters page is displayed, as shown in
Figure 7-8 Bandwidth Adaptive Parameters page
Step 2 Select Bandwidth adaptive.
Step 3 Click Save.
----End

7.5 Setting 802.1X Parameters

802.1X is a network connection protocol used to authenticate devices connected to the
network. It can prevent unauthorized users/equipment from accessing the LAN/WLAN
Issue 01 (2016-08-20)
NOTE
indicates a higher compression ratio, smoother images, and lower bandwidth requirements but longer
delay. The default value is 4.0.
Traffic shaping coefficientbased on the actual network bandwidth. If a non-Huawei platform is used, it is
recommended that the default value be used or decoding cache be increased.
Stream type is set to Primary stream.
Coding protocol is set to H.264 and H.265.
Bit rate type is set to Constant bit rate.
The dynamic bit rate function is disabled.
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Setting Network Parameters
Figure 7-8.
79