Huawei IPC6125-WDL-FA Configuration Manual page 83

IPC6125-WDL-FA
Configuration Guide
Procedure
Step 1 Choose Settings > Network Configuration > IP Filter.
The IP Filter page is displayed, as shown in
Figure 7-5 IP Filter page
Step 2 To enable the IP filter function, select Enable.
Step 3 Select an IP filter rule as required from the drop-down list box.
The IP filter rule has two options: Deny and Allow, that is, denying or allowing the access of
IP data packets coming from a specified IP network segment, port, or using a specified
protocol, to the IPC.
Step 4 Click Add.
Step 5 Set IP address, Subnet mask, Port range, and Protocol type in the Add filter rule page, as
shown in
Figure 7-6 Add filter rule page
l Both the start and end port numbers must be within the range of 0 to 65535. The start port number must
l If you select All, all port numbers within the range of 0 to 65535 are filtered.
l If a filter rule shown in
Step 6 Click OK.
The IP Filter page is displayed.
Step 7 Click Save.
Issue 01 (2016-08-20)
Figure 7-6.
NOTE
be equal to or less than the end port number.
Figure 7-6
received on port 80 from 192.168.0.200.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 7-5.
is configured under Deny, the IPC does not process TCP packets
7 Setting Network Parameters
77