Setting Parameters For A Genetec-Based Connection - Huawei IPC6125-WDL-FA Configuration Manual

IPC6125-WDL-FA
Configuration Guide
Parameter
ONVIF Expires Switch
Authentication mode
----End

3.2.4 Setting Parameters for a GENETEC-based Connection

When the GENETEC protocol is used when connecting IPCs to the platform, you need to set
the GENETEC parameters.
Issue 01 (2016-08-20)
Description
Select Enable in the ONVIF Expires Switch area to enable
the ONVIF message validity period function.
After this function is enabled, an ONVIF message when the
specified validity period is exceeded.
NOTE
The ONVIF message validity period function is valid only when
being supported by the video surveillance platform. If the platform
does not support this function but this parameter is selected, the IPC
will fail to connect to the platform. You are advised to enable this
function only when security risks exist. The ONVIF message validity
period function is disabled by default.
Select a Authentication mode from the Authentication
mode drop-down list box.
l None: indicates no authentication.
l Digest: Digest authentication mode.
l WSSE(Web Service Security): WSSE authentication
mode.
l Digest(priority)/WSSE: indicates that both Digest and
WSSE authentication modes are supported. However,
Digest authentication is performed preferentially. This
authentication mode is enabled by default.
NOTE
l ONVIF WSSE has security risks. It is recommended that Digest/
WSSE authentication mode be enabled only when the platform
supports only ONVIF WSSE.
l None authentication mode has security risks. It is recommended
that this authentication mode be enabled only when the platform
does not support authentication. While this authentication mode
is used, the system does not perform authentication if you
request live video through the RTSP, Genetec and
ONVIFprotocol.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Setting Basic Parameters
22