Setting Local Parameters - Huawei IPC6125-WDL-FA Configuration Manual

IPC6125-WDL-FA
Configuration Guide
Parameter
Rate limit
SD card
recording time
In Record status, you can view the status of recordings of different types.
l Running: The recording is enabled.
l Stop: The recording is disabled.
----End

14.5 Setting Local Parameters

You can set local parameters, such as the protocol type, data stream type, video stream type,
and path where snapshots are saved. These settings take effect only on the local PC.
Procedure
Step 1 Choose Settings > System Configuration > Local Parameters.
The Local Parameters page is displayed, as shown in
Issue 01 (2016-08-20)
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Sets the maximum upload rate for video buffering or
download rate for SD card recording.
It is recommended that the value be one fourth of the
bit rate of primary streams and not exceed the
available bandwidth.
NOTE
l The video buffering function occupies additional
network bandwidth. If the value exceeds the available
bandwidth, the network may be blocked, which leads
to image exceptions. Set Rate limit based on the site
requirements.
l The rate for downloading the recordings in the SD card
can be adjusted. However, the rate cannot be adjusted
during the download.
Sets the SD card recording duration. The SD card
recording automatically stops when the specified
recording duration ends.
The recording duration ranges from 5 minutes to
1440 minutes.
Figure 14-14.
14 Managing the System
168