Setting Traffic Shaping Parameters - Huawei IPC6125-WDL-FA Configuration Manual

IPC6125-WDL-FA
Configuration Guide
You can click Modify or Delete in an existing IP filter rule to modify or delete it.
----End

7.3 Setting Traffic Shaping Parameters

You can set the rate for sending data to ensure stable network bandwidth occupation and
enhance stability and reliability of video stream transmission.
Prerequisites
The traffic shaping function is available only when Coding protocol is set to H.264 or H.
265and dynamic bit rate is disabled.
l If the traffic shaping function is enabled, do not set bandwidth adaptive parameters to prevent incorrect
l If the traffic shaping function is enabled, when you set video stream parameters, change the traffic
l If the traffic shaping function is enabled, audio&video synchronization is not supported.
Procedure
Step 1 Choose Settings > Network Configuration > Traffic Shaping Parameters.
The Traffic Shaping Parameters page is displayed, as shown in
Figure 7-7 Traffic Shaping Parameters page
Step 2 Select Enable.
Step 3 Select Plugin delay.
l The plug-in delay function is valid only after the traffic shaping function is enabled.
l If the plug-in delay function is enabled, live video freezing and artifacts issues can be resolved in the case
Step 4 Set Traffic shaping coefficient.
Issue 01 (2016-08-20)
NOTE
NOTE
bandwidth reflection.
shaping coefficient, or manually disable the traffic shaping function, mosaic of about 1s may occur.
NOTE
of traffic shaping. However, live video images will be delayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Setting Network Parameters
Figure 7-7.
78