Configuring The Removed Object Detection Function - Huawei IPC6125-WDL-FA Configuration Manual

IPC6125-WDL-FA
Configuration Guide
Step 6 Click Save.
The abandoned object detection function is configured.
----End
Verification
When an individual enters the sensitive area and leaves an object in the area for more than 5
seconds:
l
l

9.4 Configuring the Removed Object Detection Function

The removed object detection function checks whether an object is removed from a sensitive
area. The system generates an alarm when an object is removed.
Prerequisites
Predefined sensitive areas for behavior analysis can be displayed on live video images only
when Video stream type is set to Hybrid stream. To set Video stream type, choose Settings
> System Configuration > Local Parameters.
Issue 01 (2016-08-20)
If the object is marked with a red box on the live video image, abandoned object
detection is successfully configured.
If the object is not marked on the live video image, abandoned object detection is not
properly configured or not enabled.
solutions.
Table 9-12 Possible causes
Cause
The surveillance area is too large.
The surveillance area is too small.
In the Global configuration area, verify
that Enable is selected.
The sensitive area is not in Enable state
when Behavior type is set to
Abandoned object detection on the
Behavior Analysis Parameters page.
Video alarm deployment is not Enable
on the Alarm Deployment Policy page
that is displayed when you choose
Settings > Alarm Configuration >
Alarm Deployment Policy.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Setting Intelligent Analysis Parameters
Table 9-12 lists the possible causes and their
Solution
Adjust the focal length and dimensions of
the surveillance area to ensure that the
intended object can be detected.
Select Enable.
Select the sensitive area ID from the
sensitive area list and click Enable to
enable the sensitive area.
Select Enable.
122