Cid Trunks - Samsung OfficeServ 7000 Series Programming Manual

CHAPTER 2. MMC Programming

[425] CID TRUNKS

Specifies an analog trunk line providing CID.
CONDITIONS

Check if RCM, RCM2 or CRM option card is mounted on the LP40 (OfficeServ 7400)
/ MCP (OfficeServ 7200 does not support CRM) card of the OfficeServ system and
before setting CLIP. (This MMC is not shown in OfficeServ 7100.)

The trunk line should be the line that a phone service provider provides CID through.
DEFAULT DATA
NORMAL TRUNK
ACTION
1) Press the Transfer button and 425.
2) Enter the number of an analog loop trunk line.
(e.g., 702)
OR
Select a trunk line by pressing the Volume button and
move the cursor by pressing the Right Soft button.
OR
Select all trunk lines by pressing the Message button
(DS-24SE) or the ANS/RLS button (DS-4028E).
3) Enter 1 or 0 to specify if the trunk line provides CID
or not.
OR
Select if the CID is provided by using the Volume
button and move the cursor by pressing the Right Soft
button.
4) Press the Transfer button to store the data and
complete the procedure or press the Speaker button to
store the data.
RELATED ITEMS
Program 119
Program 312
Program 608
Program 728
2-154
Specify the way to display CID.
Specify if the CID is allowed.
Assign the block to save CID.
Enter the CID Conversion Table.
DISPLAY
[701] CID TRUNKS
NORMAL TRUNK
[702] CID TRUNKS
NORMAL TRUNK
[702] CID TRUNKS
CID TRUNK
© SAMSUNG Electronics Co., Ltd.