CHAPTER 2. MMC Programming
[425] CID TRUNKS
Specifies an analog trunk line providing CID.
C ONDITIONS
5 8 9 B
Check if RCM, RCM2 or CRM option card is mounted on the LP40 (OfficeServ 7400)
/ MCP (OfficeServ 7200 does not support CRM) card of the OfficeServ system and
before setting CLIP. (This MMC is not shown in OfficeServ 7100.)
The trunk line should be the line that a phone service provider provides CID through.
D EFAULT DATA
5 9 0 B
NORMAL TRUNK
A CTION
5 9 1 B
1) Press the [Transfer] button and [414] button.
2) Enter the number of an analog loop trunk line. (e.g.,
702)
Or, select a trunk line by pressing the [Volume] button
and move the cursor by pressing the [Right] Soft but-
ton.
Or, select all trunk lines by pressing the [Message]
button (DS-24SE) or the [ANS/RLS] button (DS-
4028E).
3) Enter [1] or [0] to specify if the trunk line provides
CID or not.
Or, select if the CID is provided by using the [Vol-
ume] button and move the cursor by pressing the
[Right] Soft button.
4) Press the [Transfer] button to store the data and com-
plete the
procedure or press the [Speaker] button to store the
data.
R ELATED ITEMS
5 9 2 B
Program 119
Program 312
Program 608
Program 728
2-146
Specify the way to display CID.
Specify if the CID is allowed.
Assign the block to save CID.
Enter the CID Conversion Table.
DISPLAY
[
7
0 1] CID TRUNKS
U
U
NORMAL TRUNK
[702] CID TRUNKS
N
O RMAL TRUNK
U
U
[
7
0 2] CID TRUNKS
U
U
CID TRUNK
Samsung Business Communications