Customer On/Off Per Station - Samsung OfficeServ 7000 Series Programming Manual

[300] CUSTOMER ON/OFF PER STATION

Allows the following features to be enabled/disabled on a per-station basis.
No Option
00 ACCESS DIAL
01 MICROPHONE
02 OFF-HOOK RING
03 SMDR PRINT
04 TGR ADV.TONE
05 VMAA FORWARD
07 NGT PASSCODE
08 INTRCOM SMDR
09 FWD DELAY USE
11 FORWARD OVRD
12 RECL TO OPER
13 SLT LP OPEN
14 NO COST PRINT
15 CID TO SLT
22 NO RCL FLASH
© SAMSUNG Electronics Co., Ltd.
OfficeServ 7000 Series Call Server Programming Manual
Default
ON Determines whether a user can select a trunk or trunk
group by dialing its Directory Number (DN). This selection
should be turned off when using LCR.
ON Allows phones to be used in speakerphone mode.
ON Will allow a short burst of ring tone to indicate another call.
ON When the station is set for no Trunk Line calls to and from
this station, the station will not print on SMDR. This
includes transferred calls or calls picked up from hold or
park.
ON When this feature is set to ON, a warning tone will be
heard each time LCR advances to the next route.
ON This feature selects whether Trunk Line calls can be
forwarded to voice mail: ON, permits forward to voice
mail; OFF, no forward to voice mail.
ON When ON, the steps verifying the ring plan passcode will
be added in Ring Plan change.
OFF When the station is set to OFF, the station will not print
intercom calls on SMDR.
OFF When ON, calls will overflow to the Forward No Answer
destination when the Forward No Answer timer expires
even when the Forward No Answer feature is not
activated at the called party extension.
OFF When set to ON and the station calls another station
which has forwarding set, the call will not forward.
OFF When the station is set to ON, if the station transfers a call
and the destination doesn't answer, the call will recall to
the operator instead of the station.
OFF When ON, SLI port receives real disconnect signal
instead of busy or error tone. (VMAA or DATA ports
always receive real disconnect signal.)
OFF When ON, if replacing the handset of a regular phone when no
digit is pressed after hook flash, recall is carried out.
OFF When a MIS card is installed and this option is set to ON,
the system will provide the CID signal to SLTs.
OFF When the hook switch is flashed or the flash key is
pressed, a recall signal will not be sent to the system.
Description
2-77