Wlan Parameters - Samsung OfficeServ 7000 Series Programming Manual

CHAPTER 2. MMC Programming

[845] WLAN PARAMETERS

This MMC modifies the WLAN parameters.
WLAN PARAMETER
No Parameter
01 CODEC LIST
02 RF CHANNEL
07 VERSION
20 MAX AP CH.
21 WLAN SWTCH
SIP PARAMETER
No Parameter
0 RE-TRANS T1
1 RE-TRANS T2
2 RE-TRANS T4
3 GEN RING TM
2-404
Description
CODEC that can be used for VoIP calls between
WBS24 and terminal. G.711u, G.711a, G.726, and
G.729 can all be assigned.
Set a RF CHANNEL value that can be used by
WBS.
WLAN module version.
Set the maximum channel number of AP
If AP type is not Commercial AP, this option can be
shown.
Support WLAN switch function
In case that AP type is not WBS COMBO, this
option can be shown
Description
When using an unreliable transmission protocol
such as UDP, retransmission is required when no
reply is received. RE-TRANS.T1 TIME is the initial
retransmission interval defined in RFC2543.
Maximum retransmission interval defined in RFC
2543
RFC 2543 defines this parameter for various
purposes. For example, this parameter can be used
as the time waited by User Agent Server after
receiving ACK message in an unreliable
transmission protocol.
When using an unreliable transmission protocol, the
server cannot be sure if the client has received the
last reply. Thus, the server must retransmit the reply
for this length of time until it receives the requested
retransmission. For example, this parameter can be
used as the waiting time after sending 200 OK for
INFO.
Default
CODEC 1: G.729
CODEC 2: NONE
CODEC 3: NONE
CODEC 4: NONE
USE CH 1: 01
USE CH 2: 06
USE CH 3: 11
USE CH 4: 00
USE CH 5: 00
USE CH 6: 00
Version
00
DISABLE
Default (ms)
500
4000
5000
6000
© SAMSUNG Electronics Co., Ltd.