Samsung OfficeServ 7000 Series Programming Manual page 418

CHAPTER 2. MMC Programming
SIP Extension Configuration
No Parameter
00 SIGNAL PORT
01 IP-UMS PORT
02 EXPIRE TIME
03 NAT REG EXP
SIP Trunk Configuration
No Parameter
00 DEFAULT ISP
01 iBG EXPIRE
02 LCR SETUP
03 RCV CLI FWD
04 INCOM MODE
05 PEER CLIPTB
2-380
Description
Sets the UDP port used for a SIP station call.
Sets the UDP port used for IP-UMS calls.
This indicates how long each registration from SIP
stations will be valid. SIP stations will send the next
REGISTER message before this time value is passed.
Specifies registration expiration time for SIP stations
located under NAT.
Description
This field indicates the default SIP Carrier that will be
used for SIP trunking
When interacting with iBG, iBG sends REGISTER
message to system for link test purpose. The iBG
EXPIRE value indicates the expiration time for the iBG's
registration.
When making SIP Trunk outbound call, there exists time
interval till the outbound INVITE message is actually sent
out unless attaching '#' key in order to let system know
that dialing is done. When LCR SETUP value is set to
Enable, the system sends the outbound INVITE message
immediately
In case outgoing SIP Call, if receiver dose not want
display CLI, set this option to ENABLE and dose not
send CLI information.
This option selects how incoming calls are routed when
the MGI is used as a SIP gateway.
0 FOLLOW DID TRANS: Follows MMC 714 (default)
1 FOLLOW INCOM DGT: Follows MMC 724
2 FOLLOW TRUNK RING: Follows MMC 406
Refers to SEND CLI NUMBER (MMC 323), which
provides calling party identification when sending out a
SIP peering call.
Default
5060
5070
600
600
Default
1
10
Disable
Disable
FOLLOW DID
1
© SAMSUNG Electronics Co., Ltd.