Bri And Pri Card Restart - Samsung OfficeServ 7000 Series Programming Manual

CHAPTER 2. MMC Programming

[418] BRI AND PRI CARD RESTART

This MMC is used to restart a BRI (Basic Rate Interface) or PRI (Private Rate Interface)
card at the card level or a BRM at the module level. This action is required to update the
processor on the BRI (BRM) or PRI card with any changes in the card setup MMCs and to
put these changes into effect.
CONDITIONS

A BRI card or BRM or TEPRI (T1E1 PRI) card or TEPRI2 card must be installed in
the system.

Before setting the PRI program, the J2 jumper of the TEPRI or TEPRI2 card must be
set ON to PRI mode.
DEFAULT DATA
NONE
ACTION
1) Press Transfer button and enter 418.
Display shows first BRI or PRI circuit:
2) Dial first trunk on a BRI or PRI card. (e.g., 733)
OR
Press Volume button to select the first trunk and press
Right Soft button to move the cursor.
3) Dial 1 for YES or 0 for NO.
Pressing 1 will advance to step 4.
4) Dial 1 for YES or 0 for NO.
Pressing 1 or 0 will return to step 2.
5) Press Transfer button to save and exit.
OR
Press Speaker button to advance to next MMC.
RELATED ITEMS
MMC 419
MMC 420
MMC 423
MMC 424
2-138
BRI OPTIONS
PRI OPTIONS
S/T MODE
BRI S0 MAPPING
DISPLAY
[725] RESTART
CARD RESTART?NO
[733] RESTART
CARD RESTART?NO
[733] RESTART
CARD RESTART?YES
[733] RESTART
ARE YOU SURE?YES
© SAMSUNG Electronics Co., Ltd.